Correction
SCPI Commands
SENSe:CONFigure:CORRection
- class CorrectionCls[source]
Correction commands group definition. 1 total commands, 0 Subgroups, 1 group commands
- set() None [source]
# SCPI: [SENSe]:CONFigure:CORRection driver.applications.k30NoiseFigure.sense.configure.correction.set()
This command configures the software to perform calibration measurements. Using method RsFswp.Applications. K30_NoiseFigure.Initiate.Immediate.set then initiates a calibration instead of the actual measurement, until you deliberately select one of the normal measurements again with one of the following commands.
INTRO_CMD_HELP: Prerequisites for this command
[SENSe:]CONFigure:FREQuency:CONTinuous
[SENSe:]CONFigure:FREQuency:SINGle
[SENSe:]CONFigure:LIST:CONTinuous
[SENSe:]CONFigure:LIST:SINGle
Note that calibration data is used only when the second stage correction mode has been turned on with [SENSe:]CORRection[:STATe].
- set_with_opc(opc_timeout_ms: int = -1) None [source]
# SCPI: [SENSe]:CONFigure:CORRection driver.applications.k30NoiseFigure.sense.configure.correction.set_with_opc()
This command configures the software to perform calibration measurements. Using method RsFswp.Applications. K30_NoiseFigure.Initiate.Immediate.set then initiates a calibration instead of the actual measurement, until you deliberately select one of the normal measurements again with one of the following commands.
INTRO_CMD_HELP: Prerequisites for this command
[SENSe:]CONFigure:FREQuency:CONTinuous
[SENSe:]CONFigure:FREQuency:SINGle
[SENSe:]CONFigure:LIST:CONTinuous
[SENSe:]CONFigure:LIST:SINGle
Note that calibration data is used only when the second stage correction mode has been turned on with [SENSe:]CORRection[:STATe].
Same as set, but waits for the operation to complete before continuing further. Use the RsFswp.utilities.opc_timeout_set() to set the timeout value.
- param opc_timeout_ms
Maximum time to wait in milliseconds, valid only for this call.