Level

SCPI Commands

SENSe:ADJust:LEVel

class LevelCls

Level commands group definition. 1 total commands, 0 Subgroups, 1 group commands

set() → None

# SCPI: [SENSe]:ADJust:LEVel
driver.applications.k70Vsa.sense.adjust.level.set()

Initiates a single (internal) measurement that evaluates and sets the ideal reference level for the current input data and measurement settings. Thus, the settings of the RF attenuation and the reference level are optimized for the signal level. The R&S FSWP is not overloaded and the dynamic range is not limited by an S/N ratio that is too small.

set_with_opc(opc_timeout_ms: int = -1) → None

# SCPI: [SENSe]:ADJust:LEVel
driver.applications.k70Vsa.sense.adjust.level.set_with_opc()

Initiates a single (internal) measurement that evaluates and sets the ideal reference level for the current input data and measurement settings. Thus, the settings of the RF attenuation and the reference level are optimized for the signal level. The R&S FSWP is not overloaded and the dynamic range is not limited by an S/N ratio that is too small.

Same as set, but waits for the operation to complete before continuing further. Use the RsFswp.utilities.opc_timeout_set() to set the timeout value.

param opc_timeout_ms

Maximum time to wait in milliseconds, valid only for this call.