Result

SCPI Commands

SENSe:ADEMod:PM:TDOMain:RESult
class ResultCls[source]

Result commands group definition. 1 total commands, 0 Subgroups, 1 group commands

get(trace_mode: TraceModeB) → float[source]
# SCPI: [SENSe]:ADEMod:PM[:TDOMain]:RESult
value: float = driver.sense.ademod.pm.tdomain.result.get(trace_mode = enums.TraceModeB.AVERage)

This command reads the result data of the evaluated signal in the specified trace mode. The data format of the output data block is defined by the FORMat command (see method RsFswp.FormatPy.Data.set) . The trace results are configured for a specific evaluation. The following table indicates which command syntax refers to which evaluation method, as well as the output unit of the results.

Table Header: Command syntax / Evaluation method / Output unit

  • ACV[:TDOMain] / AC-Video time domain / V

  • ACV:AFSpectrum / AC-Video spectrum / V

  • AM[:ABSolute][:TDOMain] / RF time domain / dBm

  • AM:RELative[:TDOMain] / AM time domain / %

  • AM:RELative:AFSPectrum / AM spectrum / %

  • FM[:TDOMain] / FM time domain / kHz

  • FM:AFSPectrum / FM spectrum / kHz

  • PM[:TDOMain] / PM time domain / rad or °

  • PM:AFSPectrum / PM spectrum / rad or °

  • SPECtrum / RF spectrum / dBm (logarithmic display) or V (linear display) .

param trace_mode

WRITe | AVERage | MAXHold | MINHold

return

trace_mode_result: The specified trace mode must be one of those configured by SENS:ADEM:Evaluation:TYPE, see [SENSe:]ADEMod:SPECtrum[:TYPE]. Otherwise a query error is generated.